Headsetholder - no screws!
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This headset holder is great for everyone trying to avoid screws. It works perfectly fine with 50mm wide double sided tape or 2x 30mm double sided sticky pads, but you should avoid too thick pads (<1mm).
This holds up pretty well due to the increased surface of the base plate (60x60mm) and can also hold heavier gaming headsets.
I used PETG for this print, but it works with PLA as well. I would recommend PLA+ (or whatever the different manufactures call their enhanced PLA) though.
Print Settings
Printer:
Sovol SV05
Rafts:
No
Supports:
Yes
Resolution:
0,2mm
Infill:
25% (Cubic)
Filament:
eSun PETG
black
Notes:
Wall count: 3
Support: overhang angle: 80° > so it just supports the "inside" (you can try without but not recommended); Grid 15%, 1 Wall, no roof or floor
Support can be removed easily!
At 80mm/s the print time was about 100 minutes.
Category: Audio