Makercat Coin
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A cat-oriented makercoin.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 151
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Art & Designs
- Licencja
- Creative Commons — Attribution — Share Alike
Introduction
This is my first attempt at 3D modelling, and true to tradition, I decided on a makercoin. I put all the stuff I love into this: gears, cats, multi-colour prints, and hex nut insets. The result is about 8mm thick, mostly due to the hex nuts needing 3mm insets.
How to make
The pictures show a print using KiwiFil rPETG. The colours I used were Electric Blue for the coin body and Black for the outline and cat face. You can use PLA if you prefer, which KiwiFil also have.
Recommended settings:
- 0.2mm layer height
- 20% infill (but it really doesn't matter)
- No supports (doesn't need them)
- No brim or raft (doesn't need it)
- 2 perimeters (but you can use more if you want)
For the colour change, assuming 0.2mm layer height, insert a change command at layer 31 (6.2mm up). I recommend a 0.4mm nozzle; a 0.6mm might work, but there are some thin lines (such as the bridge of the glasses) that might not print well with one. I used a 0.4mm nozzle for mine.
If you want to insert the nuts into the back, useM3 hex nuts. They should fit fairly snugly, but I haven't tried screwing anything into them. They're meant to be decorative anyway.