HK paddle jig
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an improved 1 piece jig for drilling the hole for installing a paddle release. I modeled it to fit tightly…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 74
- Wydruki
- 0
- Wyświetlenia
- 330
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
This is an improved 1 piece jig for drilling the hole for installing a paddle release. I modeled it to fit tightly onto the Century C93 receiver.
It is a snug fit and will require a rubber mallet to fully install the jig on the receiver. Once it is on all they way insert the pin. Drill the hole from one side with an 1/8" bit. From the same hole spot drill a blind hole on the other side. Only drill the hole about 1/16" deep.
The jig should also work with other Century HK clones, but I'm not able to test it.
The Fusion 360 file is included.
Print Settings
Rafts:
No
Supports:
No
Infill:
20%
Notes:
Prints as oriented without supports.
Use 5 top and bottom layers and 5 shells.Category: Tools