Segmented Dice Tower v3
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My take on a dice tower making use of multiple segments and zero supports
- Ocena
- 4,944 / 5
- Polubienia
- 375
- Pobrania
- 1771
- Wydruki
- 25
- Wyświetlenia
- 6931
- Oceny
- 18
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Miniature Gaming Accessories
- Licencja
- Creative Commons — Attribution
General
Don't forget to check out the other models:
- Version #1
- Version #2
- Version #3 (this model)
Prolog
This dice tower was inspired primarily by my work by multiple artists. However, this model was created from scratch (not a remix) to allow for:
- Printing without supports
- Making it printable on smaller machines
- Disassembly for transport
- The flexibility to have short to freakishly tall towers
Printing Instructions
To print, start with the base, middle, and the battlement. You can later print as many middle sections as you like, each adding ~40 mm to the height and rotating the battlement 96 degrees.
WARNING: The "segments" do not require support; however, the "complete" models should not be printed as-is. Supports are required for the battlement (because of its flat roof), and because it is a closed mode, you will not be able to get inside of it to remove any supports you may add. I included them here to demonstrate the different options. That said, they have been successfully printed without support, relying on the PLA to bridge the gap and eventually create a solid roof/floor.