1 / 23
Christmas present bow maker
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This tool allows you to turn regular 10mm (3/8") wide ribbon into a nice bow.
- Ocena
- 5 / 5
- Polubienia
- 553
- Pobrania
- 1399
- Wydruki
- 18
- Wyświetlenia
- 8260
- Oceny
- 16
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Winter & Christmas & New Year's
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 18) (Komentarze: 23)Remiksy (1)Kolekcje (854)Powiązane
With this template you can turn a piece of 10mm (3/8") present ribbon into a nice bow to put on your Christmas, valentine and other presents.
You need:
- 3,25m of 10mm wide ribbon (or 10 feet and 8" of 3/8" ribbon)
- scissors
- a stapler
- a piece of tape
Steps:
- Print the attached model (obviously :-)
- Cut 3.25m of ribbon (10 feet and 8")
- Thread the start of the ribbon through the 2 slots
- Now wrap the ribbon around the number 1 tab (from left to right)
- Continue and wrap the ribbon around number 2
- Keep going until you reach 8 and continue to number 1 again
- Keep going until you've almost used all of the ribbon (this is around 5 times from 1 to 8)
- Put 2 staples in the middle of the template to fix the ribbon in place
- Now gently remove the template from the ribbon tab by tab (it is printed thin enough to allow a some bending)
- Separate the layers of each of the tabs of the ribbon
- Now put a piece of wrapped around (or double sided) tape and stick the protruding end in the center to the bottom (making a small loop).
- Cut the other end so it doesn't protrude the bow.
- To stick the bow to the present, use another piece of wrapped around (or double sided) tape.
