Base and Slider with built in magnets for 3D-printys Dracula's Tower

If you are like me and you prefer to avoid using glue whenever possible this is the remix for you!

The uploaded .3mf file remixed versions of the Base and the Slider of Dracula's tower which have 2 pauses in the print at the correct heights for inserting 6x3mm magnets into the parts.

The pieces are oriented so that the magnets go in with the same polarity facing the build plate. To make it easy to keep track of the polarity i usually grab a stack of magnets and put a color marking on the topmost magnet and then proceed to add them to the print with that magnet ALWAYS facing upwards (se pictures). This ensures that the mechanism for the tower works as intended when the print is done.

The first pause is about 55ish minutes in and that is for placing magnets into the SLIDER (the smaller piece located to the right on the build plate)

The second pause is 6ish minutes later and is for placing magnets into the BASE (the bigger piece on the left side)

Time estimates are for a stock mk3s+ and will probably vary a lot depending on your printer.

The dimensions for the holes for the magnets have a diameter of 6,2mm and a height of 3,4mm which ensures some leeway for placing them and also a satisfying clicky sound when using the slider. All four magnets are covered with 3 layers (if printing at 0,2mm layer height) or a total of 0,6mm per side. So the total distance between the magnets in the finished print is 1,2mm which works perfectly for the strength of the neodymium magnets i got from Amazon.

The rest of the pieces for the tower can be grabbed from the original version by 3d-Printy:
https://www.printables.com/model/296319-draculas-tower-puzzle-box

Happy printing :)