Working Cannon (Not Print in Place)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Assemble with a 9 x 35mm compression spring
- Ocena
- 5 / 5
- Polubienia
- 60
- Pobrania
- 293
- Wydruki
- 2
- Wyświetlenia
- 1367
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Here is a remix of the Print in Place Cannon by Makkuro.
I really like the original and the print in place design is very well done.
I found though that PLA was not very forgiving and coil spring broke after just a few fires.
This remix takes Jürgen Weigert rounded design, removes the firing mechanism and includes a seperate plunger with a screw on knob so that a compression spring can be added post print.
In my design I uses a 9mm diameter by 35mm long compression spring. I had this in a kit of springs I bought on Amazon a while back, but you could use any compression spring from 7mm x 30mm upto 14mm x 40mm, although I haven't confirmed these sizes.
The knob is a screw fit and easily removed, so different springs can be tested. If you already printed the thick rod version of the original and the spring broke, you could possibly retro-fit the plunger to the original print.
I printed mine with .6 nozzle .2 layers.