Anbernic RG353V Snap On Face Protector
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
rough but decent faceplate since there are none out there for the RG353V.
- Ocena
- 0 / 5
- Polubienia
- 23
- Pobrania
- 267
- Wydruki
- 0
- Wyświetlenia
- 1826
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial
Prints fine without supports. Turn on ironing to clean up the inside faceplate that actually makes contact with the rg353v. I used a roll of felt tape to line the inside from amazon. This is really rough as this is my first remix but works well for my needs. Will be doing some micro adjustments to sizing but seems to keep the handheld from not falling out.
12/23/2022 update: realized there was a small line gap on the faceplate which if the printer is too dialed in will be pronounced in the print. fixed it and adjusted the height to make the plate alittle tighter
12/25/2022 update: make the directional pad bigger so the handheld sits flush against the cover
01/16/2023 update: moved the "wings lower makes for a better fit and snugness to the handheld