Eryone Thinker SE Linear Rails Y Axis Mod (Remix)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Want more stability than a single carriage. Remix this to use a 450mm Linear Rail with 2 MGN12C Carriages. Has 2…
- Ocena
- 5 / 5
- Polubienia
- 5
- Pobrania
- 24
- Wydruki
- 1
- Wyświetlenia
- 417
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Want more stability than a single carriage. Remix this to use a 450mm Linear Rail with 2 MGN12C Carriages.
Has 2 designs:
- 1 with a Bracket broken into 2 pieces like the original design and can be printed with not support. (Bracket_Left, BracketSpacer_Left, Bracket_Right, BracketSpacer_Right)
- The other with one piece that will require the pieces to be printed upside down and add support for the screw insets, which I preferred. (BracketNoSpacer_Left, BracketNoSpacer_Right)
Both designs require printing the BeltSpacer which handles the attachment or the Y Axis Belt and the end stop bumper for the Y Axis sensor.
If you reuse the existing M5 screws from the bed, it is required to print 6 x ScrewSpacer(s).
Assembly required 16 x M3 6mm screw for the attaching the adaptor to the Linear Rail MGN12C Carriages. 6 x M5 screw from the existing bed, else you can use 6 x M5 12-14mm if you want to not print the Screw Spacers. It is also need to have 2 x M3 20mm to attach the Belt Spacer
Print Settings
Printer:
Eryone Thinker
Rafts:
No
Supports:
Doesn't Matter
Resolution:
0.2
Infill:
20%
Filament:
Eryone PETG
Orange, Black Post-Printing =============
Assembly
- Remove the existing bed, remove the bed from the aluminum plate and remove guide screws. Install both 450mm Linear Rails to Y Axis 2020 extrusions, leave the screws loose for now. Install the Bracket Adaptor parts to the MGN12C Linear Rail Carriages with 16 x M3 screws and check that the part hits the end stop correctly. Attach the aluminum plate to the Bracket Adaptor with the 6 x M5 screws Now slide the bed to the front and tighten the front screws on the Linear rail and then do the same on the back so the glide is straight, then tight the remain screws on the rails Attach the Belt Spacer to the aluminum plate and Y Axis belt using 2 x M3 20mm screws. Now reattach the Main bed frame to the aluminum plate with the leveling screws and re-level the bed. Reconnect the printer and start testing the Y axis linear motion.
Category: 3D Printer Parts