Charging Dock For Ulanzi I-Light
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple yet useful charging dock station for the Ulanzi I-Light.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 204
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I picked up 2 of these little photography lights from Ulanzi a while back. They work great for nice photos and close ups, but I never have a convenient place to charge them.
I designed this docking system that uses the stock type-c cables provided with the lights. The dock comes in variants holding 1, 2, or 4 of the lights.
To setup the dock to charge your lights simply slide the type-c cable in at the back on an angle, and push down until it's held firmly in place. From there to charge your Ulanzi I-Lights all you have to do is slide them straight in and they will begin to charge.
The dock prints quite easily and depending which one you choose should fit on pretty much all FDM printers. I opted to make mine in Overture's Matte Black PLA as it fit the aesthetic of the room I put it in. The only part that could cause some difficult is the two little arms that hold the cable, but it should print just fine assuming the printer isn't way out of whack.