Nuki Lock angled knob
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an angled knob cover for the Nuki Lock. My problem was, that the original knob collided with my doorframe.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 518
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
This is an angled knob cover for the Nuki Lock.
My problem was, that the original knob collided with my doorframe. To install my Nuki lock, i had to design a 45 degree baseplate and a new knob cover.
To change the knob cover, you have to remove two little screws. Then you can pull off the original cover.
After you finished your print, you have to break the button free. To do this, gently push the ring from inside.
I also published the Fusion360-file for remixing or improvements. If the knob doesn't fit perfectly, try adjusting the marked faces (see screenshots).
Also, there is a second model, which inner ring is a little bit lower. This leads to a flatter button.
The model is still a work-in-progress.