#0049 Quick Overhang Test Vase Mode [All 4 Directions at Once]
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tests Overhang in Vase Mode, all 4 directions at once
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 78
- Wydruki
- 0
- Wyświetlenia
- 466
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a quick overhang test using vase mode. It can test your printer's performance in different extrusion widths, in all 4 directions at the same time. The angles vary from 45° to 70°. The base is marked with FRBL for front, right, back, and left, respectively so you can compare how each side performs in one test.
If your test print did not look as good as you'd like, there are a few things to consider changing:
- Increase your fan speed
- Decrease your print speed
- Upgrade your fan duct and/or fan. There are some great duct upgrade options to try on printables.com, including the ones that I've contributed, found here (X2 Delta P), and here, and here.
The test prints shown here are using 0.4mm diameter extruder and 0.45mm extrusion width and 0.65mm extrusion width in vase mode.
NOTES for Printing:
- Use Spiral Vase Mode.
- Use bottom layer 4.This is to create a strong base as well as direction labels to help with your evaluation.
- Print speed: 25mm/s for external perimeters.
- The wider 0.65mm extrusion width generally does better than the 0.45mm extrusion width, as you would expect, due to the higher “extrusion width/layer height” ratio.
If you add this to your collection and/or download the model, please click the LIKE button and give it some STARS!
Remember, you can earn some Prusameters if you post a pic of your make! Plus, it would make my day to see it. ;-D
Happy Printing!