1 / 5
Gunholder for 2 Guns when you run out of storage space — zdjęcie 1
1 / 5

Gunholder for 2 Guns when you run out of storage space

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

First of all: THIS THING IS A GUN-HOLDER AND HAS NOTHING TO DO WITH NOT COMPLYING ANY WEAPON LAWS. It is just a…

Ocena
0 / 5
Polubienia
13
Pobrania
50
Wydruki
0
Wyświetlenia
1027
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

First of all: THIS THING IS A GUN-HOLDER AND HAS NOTHING TO DO WITH NOT COMPLYING ANY WEAPON LAWS. It is just a storage help for guns! Would you please bear this in mind.

I had not enough space in my gun cabinet. Long rifles ok, but hand-guns could only be stored in upright position.

So I designed a holder for two guns (Feinwerkbau FWB AW93 and CZ75 Taipan Pro Tuning):

You store the guns in upright position. To release, pull the orange knob, this withdraws a slider, releases a notch. With the other hand you catch the gun smoothly.

After your visit in the shooting range AND cleaning your weapon, you slide the gun back into the apropriate shaft, push it back (approx. 60°), the spring loaded slider snaps back and locks the gun. Period.

Print Settings

Printer Brand:

Prusa

Printer:

i3 MK3

Rafts:

Doesn't Matter

Supports:

Yes

Resolution:

0.2mm (quality). Prusa Slicer.

Infill:

your choice, I took 25%

Filament: Doesn't matter PLA (others are your choice) I chose different colors.


Notes:

All screw holes are prepared, I almost did no fine tuning, except a few hole-drillings to make best fit.rnrnI bet you'll figure it out.rnrnOne STL-file is the ZSB (assembly)

Category: Sport & Outdoors

Tagi