Silica canister for round meter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Scratching my own itch.
- Ocena
- 5 / 5
- Polubienia
- 23
- Pobrania
- 133
- Wydruki
- 1
- Wyświetlenia
- 1212
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Scratching my own itch. These simple canisters are designed to use the cheap, round temp/humidity meters I found on Amazon, and fit inside the hub of most the filament spools I had laying around. So they work in a dry box, or bags with no problem.
They have an outer diameter of 50mm, and a height of 65mm. The center is 40mm.
Fill with bulk silica/desiccant, and pop in a meter. Use silica gel with a diameter of 2-4mm so they don't fall through the openings. Make sure to give them a good shake over a trash can, inevitably a few small beads will slip through.
Silica Dessicant:
https://www.amazon.com/dp/B01I5Y2DG6/ref=cm_sw_em_r_mt_dp_U_5K1wDbQ2RK6ZE
Hygrometer:
https://www.amazon.com/dp/B07PWFDB3T/ref=cm_sw_em_r_mt_dp_U_lwZwDbEBHXWQE
I printed them with .25mm layers, .4mm nozzle, 2 shells, and no infill in PETG. Pretty simple design, doesn't need anything fancy. If using a bowden, it could easily have stringing issues if retractions are off.
Print instructions
Nothing special. Prints fine in PETG or PLA.