Poop bag container for Flexi dog retractable leash
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Poop bag container with hook compatible with the attachment mechanism on Flexi dog retractable leashes.
- Ocena
- 4,846 / 5
- Polubienia
- 50
- Pobrania
- 278
- Wydruki
- 14
- Wyświetlenia
- 1530
- Oceny
- 13
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I originally printed a couple of the original model but after a squirrel incident where one dog went one way and the other the opposite way, one of the leashes got caught around one of the containers and it cracked in half sending the roll of poop bags within flying like a roll of toilet paper being thrown over a tree. Having used them for a few months I had a list of a few things I wanted to change and now I had a reason.
The main change is turning the container 90deg so it's parallel with the handle rather than perpendicular. Not only does this make the whole thing a bit more sleek it also means it can be printed without supports saving a ton of hassle removing the supports from between the hook “teeth” on the original. While using the original I found putting a new roll in the container to be very difficult so rather than a hole in the middle of the side I changed it to be a slit which goes all the way to the top so the first bag of the new roll can simply be slid in. It still tapers at the end to make a it a bit easier to tear off a bag one handed. Similarly, the spindle on the original snapped off the first time I tried to put a roll in so I shortened it significantly and put an identical spindle on the inside of the lid to achieve the same function with much less chance they'll break off. The original hook worked okay but there were a few times where the bag it was holding fell out either because I tilted the leash a bit too much or had to yank my dog back (other squirrel incidents) and the momentum of the bag caused it to fly right off. To make that much less likely I made the opening of the hook much narrower. Finally, I shrunk the diameter of the lid a bit so it's flush with the outer diameter of the container for an even more sleek look.
Printing
I printed with this with my fast draft profile (0.28mm layer height, 10% infill, no supports) using some old PLA scraps and it turned out great if not without some minor extrusion issues probably due to the age of the PLA. I think if I didn't have the scraps lying around I would've printed in PETG for the extra durability and UV resistance.
