1 / 5
AirTag snowboard / motorcycle / bicycle watertight stick up enclosure - attach - case — zdjęcie 1
1 / 5

AirTag snowboard / motorcycle / bicycle watertight stick up enclosure - attach - case

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is an apple AirTag enclosure to attach it to a snowboard or any other surface with some double sided tape.

Ocena
4,75 / 5
Polubienia
68
Pobrania
368
Wydruki
5
Wyświetlenia
2578
Oceny
4

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial

The model is designed to house an apple AirTag, with a screw in top (cap) and an o-ring for water tightness.

I'm also including the fusion 360 file for anyone to make an easy remix there.

 

Printing recommendations

  • Printing the base and top (cap) on any regular PLA should be enough.
  • O-ring should be printed on TPU or any other elastic material.
  • slow speeds.
  • low layer height so that the screwing pattern prints nicely.
  • no support needed. But you can add some support for the base offset where the double sided tape goes.

 

Other instructions

  • use 1mm double sided tape at the base offset to stick it to any surface
  • IMPORTANT: when inserting the AirTag do it on the top (cap) with the metal part facing outward. This way you can easily remove it whenever you need.
  • ALSO IMPORTANT: Don't stick it to the top or bottom parts of the board as it may get detached when putting your board in a gondola side carrier. Its better to stick it on the inside middle section right next to either of the bindings.

 

Tagi