1 / 5
PTFE to PTFE Straight Connector - 2020 Extrusion Mounted — zdjęcie 1
1 / 5

PTFE to PTFE Straight Connector - 2020 Extrusion Mounted

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a connector I designed to splice two 4mm OD/2mm ID PTFE tubes. It's meant to be mounted on a 2020 extrusion,…

Ocena
4,5 / 5
Polubienia
38
Pobrania
278
Wydruki
2
Wyświetlenia
1055
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial

This is a connector I designed to splice two 4mm OD/2mm ID PTFE tubes. It's meant to be mounted on a 2020 extrusion, but can be put on a flat surface, as well.

Using two PC4-M10 couplers

The channel for PTFE tubing between the connectors' ends is only 6mm deep. To make sure your PTFE tubes meet within the channel, screw in one connector and thread in some PTFE until you can tell it's made it into the channel. Then screw in the second connector.

Bulkhead coupler version

2021-2-12: I added a new file that takes a bulkhead union coupler that only needs one connector. They can be hard to find, so there's an Amazon link below. Beduan sometimes sells five packs, too.

Because of the width of the coupler, this can't be mounted across a pair of 2020 extrusions or a 2040 extrusion, but it can be mounted sideways.

You will need

  • 2x M4x8mm screws with tee nuts
  • 2x PC4-M10 PTFE couplers (PTFE to PTFE coupler.stl)

*or 1x 4mm/4mm OD bulkhead union quick connect coupler (PTFE Bulkhead Coupler Mount.stl)

Print Settings

Printer Brand:

Creality

Printer:

Ender 5

Rafts:

No

Supports:

Yes

Resolution:

0.2

Infill:

25%

Filament: 3DFuel PLA+ Any


Notes:

Print as the STL is, so that it's standing up. I recommend three perimeters, as well.

Category: 3D Printer Accessories

Tagi