Neck Shave Guide & Guard
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I actually started shaving my own head in November of 2019 and came up with this to trim my neckline. I figure it…
- Ocena
- 4,5 / 5
- Polubienia
- 32
- Pobrania
- 188
- Wydruki
- 1
- Wyświetlenia
- 1447
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial
I actually started shaving my own head in November of 2019 and came up with this to trim my neckline. I figure it should be helpful for anyone living alone in self-quarantine.
The peg is a handle. Just place the half-circle over your neck where you want your hairline to start and keep your non-dominant hand on the handle. Then shave your neck below the guard. I find shaving up to the guard (instead of down and away from) gives a more even result.
It's a pretty straightforward print. I like 20% cubic prints for durability and 0.2mm layers.
9-28-2020: Added V2, an easier and faster print
Print Settings
Printer Brand:
Wanhao
Printer:
Wanhao Duplicator i3 V2
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.2mm
Infill:
20% cubic
Filament: 3D Solutech PLA Silver
Notes:
Any infill will probably work, but 20% cubic gives some sturdiness.
Category: Bathroom