Everything Presence One - MMWave Stabilisation Sleeve
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple sleeve that slips around the MMWave header to improve stability.
- Ocena
- 5 / 5
- Polubienia
- 25
- Pobrania
- 252
- Wydruki
- 2
- Wyświetlenia
- 2359
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The MMWave sensor in my Everything Presence One was a little ‘wobbly’.
This is a very simple sleeve that slips over whichever header you are using and removes angular torque from the MMWave pins.
The render shows the part mounted on the side MMWave header - coloured in gold.
Print at 0.12 layer height.
I am the designer of the official EP1 case.
You can check out my range of tablet wall mounts by following this this link.
These are also available to purchase pre-printed.
Web site (UK shipping only): https://the3droom.co.uk
eBay (Global shipping): The 3D Room on eBay