Hall sensor for fischertechnik
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a case for Hall-Effect Switches (Hall sensors) compatible with the fischertechnik construction toy system. It…
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 476
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Building Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a case for Hall-Effect Switches (Hall sensors) compatible with the fischertechnik construction toy system.
It can be used as end stop, rotary counter etc. Needs a suitable magnet, for fischertechnik I recommend 4x4mm cylindrical neodym. Pins are labeled O for Out, ⏚ for GND and V for Vin. Don't forget a pullup resistor on the output, the microcontroller's internal pullup will do fine.
Designed for Micronas HAL 525, HAL 526 Hall-Effect Switches
However, the form factor is quite common so I assume it will fit for similar sensors, too.
Bend back the sensor's legs, clip them to length and solder them to a 5 pin male pin header, remove the two outer pins and you're ready for assembly.
Previously published at Youmagine
Category: Construction Toys