KODAK SLIDE N SCAN Storage Shelf
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The KODAK SLIDE N SCAN is a small film scanner that offers scanning of 135 (35mm), 126, and 110 film as well as 35mm…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 423
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution
The KODAK SLIDE N SCAN is a small film scanner that offers scanning of 135 (35mm), 126, and 110 film as well as 35mm slides.
It is one of the few slide scanners that offer scanning of 110 and 126 film sizes which were very common formats for family snapshots in the 1970s and 1980s.
A slide holder, three film adapters, and a cleaning brush are included with the scanner. However, there is no case to store all these accessories.
This design offers storage for these accessories, a spot for storing a Sharpie (good for marking slide sleeves), and another bin for holding a pair of gloves. In the rear of the enclosure is a recess to store the excess length of the USB cable.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
200
Infill:
20%
Filament: Hatchbox PLA True Black
Notes:
This was printed with a Creality CR 6-SE with a 200C hot end and a 65C bed.
The print was positioned so the rear side of the shelf was on the build plate. This eliminated the need of supports. A brim was used to reduce the risk of corner lifting off the plate. This may not be necessary.It requires approximately 265g of filament.
Post-Printing
There are four recesses on the base of the shelf to accommodate rubber non-slip feet.
The M4 screw hole at the rear recess can be used to keep the USB cable constrained to the recess hole. Depending on the length of excess cable placed in the recess this may not be necessary.
The two M4 screw holes in the middle of the base are for a future accessory add on.
If you would like to use any of these holes you will need to clean the holes with an M4 tap.
Category: Camera