Strawberry Plant Support
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Are you trying to grow strawberries only to find the underside of your beautiful red berries have holes or rot in the…
- Ocena
- 5 / 5
- Polubienia
- 36
- Pobrania
- 142
- Wydruki
- 1
- Wyświetlenia
- 1283
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution
Are you trying to grow strawberries only to find the underside of your beautiful red berries have holes or rot in the bottom? Keep your strawberries elevated off the ground, away from excess moisture and ground-dwelling insects with a strawberry plant stand/support.
Getting Started
You will need the following non-included parts:
- (2) M4 x 50mm Machine Screws
You may need the following additional tools:
- Metric M4 Tap Set
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
200
Infill:
20
Filament:
Hatchbox PLA
Notes:
IMPORTANT: Please review each part in your slicing software before printing to ensure a logical face is touching the build plate!
This was printed on a Creality CR-6 SE with the hot end set at 200C and the bed set at 65C.Please see the following print notes below.
Infill: 20%
Quantity: 2
Material Required: 1g - Hatchbox Cool Gray (or Green) 1.75mm PLA
Adhesion Type: Skirt
Supports: None
Positioning: Top Side Down / Ground Spikes Up
Post-Printing
Use the M4 tap set to clean the threads the holes in each piece.
Attach the two halves together using the M4 x 50mm machine screws.
Category: Outdoor & Garden