HDMI Cable Retainer for HDO2 Goggle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
If you're like me you're constantly accidentally pulling out the HDMI cable from the HDO2 in flight. I move my head…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 139
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
If you're like me you're constantly accidentally pulling out the HDMI cable from the HDO2 in flight. I move my head around like Stevie Wonder when I fly and if the cable gets pulled out you're flying blind.
I suggest printing each of these models in pairs, because they are on the small side and will tend to overheat if you don't.
In addition to the two prints you will need the following to complete the assembly:
5mmx25mm hex socket head screw
5mm heat set insert. 6.8mm long
Press on thumb screw knob for 5mm screws
Thin double sided tape cut to shape
3/32" rubber sheet cut to shape
This is designed for thin cable. I bought my cable which is type c male to male 10' long at mycablemart. Great place super cheap cable and very good.
If your cable doesn't fit comment with the head dimensions and I will mod the design for you.
Print Settings
Printer Brand:
MakerBot
Printer:
MakerBot Replicator 2
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
50%
Filament: Gizmo Dorks ABS White
Notes:
Again, print both models in pairs or they may overheat during printing.
Category: R/C Vehicles