Elegoo Neptune 2 SKR Pico Mounting system
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
For fitting a BTT SKR Pico at the rear of the unit (so as not to have to extend the cables) on top of a full size pi
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 52
- Wydruki
- 0
- Wyświetlenia
- 816
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
I wanted to upgrade the original Robin board to an SKR pico and run klipper on the Neptune, so I designed a mounting system. I originally wanted it to be mounted where the robin board was, but the cables weren't long enough, so I mounted it to the rear instead, which allowed enough height to mount the pi under (using 20mm M2.5 spacers). The existing 5015 fan in the controller cavity is relocated under the Y axis beam. The cable cover stops the cables from getting tangled as the bed moves back and forth.
You'll need:
2xM3x4mm heat inserts (for fan mount)
2xM3x18 bolts for the fan
6xM5x12 CSK bolts
4xM2.5 nuts
4xM2.5x20mm spacers
5xM5x8mm button head bolts
11xM5 T Nuts
I currently run this headless, I will eventually try and make an adapter to make a touchscreen compatible with the pi fit where the existing touchscreen sits. I would also recommend that you change the config of the controller fan to always on, as my pi got hot on idle (without the bed on!).