Hexagonal/Standard Sunglasses Car Clip - No Supports!
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Small and sturdy clip to hold your shades on your sun visor!
- Ocena
- 5 / 5
- Polubienia
- 163
- Pobrania
- 1069
- Wydruki
- 12
- Wyświetlenia
- 3050
- Oceny
- 11
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Do NOT print this in PLA, Use a high temperature resistant material for best results and longevity! (Recommended: ABS, ASA, etc. PETG will work but will deform over time, especially in hotter climates)
Best suited for thicker frame sunglasses. Not designed for thin framed eyewear.
I developed two models, one primary hexagonal design for those brave enough and a solid design for those beginners or general users.
These clips also work not just in cars but surprisingly well sitting on a flat surface!
Print Settings (for both models):
- Again, Print using a high temperature resistant material like PETG, ABS, ASA, Nylon, etc. Not PLA!
- Infill at 100% for strength and to prevent deforming.
- Be sure to have your overhangs very well tuned for your particular material!
- Use 3 Perimeters to reduce print time. (Model is 2.4mm thick all around)
- Supports are not needed for well tuned printers, however it will not hurt to use supports on the build plate for assurance.
Inspiration:
This model was made from scratch using general concepts of existing models. Many of the models I had come across appeared to be too skinny for my liking. So, I found a design I really appreciated by Celta (Sunglasses Car Clip), huge thanks for the inspiration! There were many things I believed that worked well with that model. However, I found in using it for quite some time, my sunglasses tend to wobble or slide out of place. Therefore, the wider clip was born!