1 / 11
filament guide in Prusa Enclosure in old way - 2.trial / vedení filamentu v Prusa Enclosure postaru - 2.pokus — zdjęcie 1
1 / 11

filament guide in Prusa Enclosure in old way - 2.trial / vedení filamentu v Prusa Enclosure postaru - 2.pokus

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

alternative guiding the filament in Prusa Enclosure / alternativní vedení filamentu v Prusa Enclosure

Ocena
0 / 5
Polubienia
2
Pobrania
24
Wydruki
0
Wyświetlenia
364
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Prusa Enclosure is super, but I don't like the filament guidance in the long tube directly into the extruder because of the color change and the end of the spool. I tried this  - https://www.printables.com/cs/model/348293-filament-guide-in-prusa-enclosure-in-old-way-veden  but it's not optimal - maybe it would help to lead the entire bowden with a piece, but I'm too lazy to try it - the part near the spool would have to be redone maybe. Therefore, the second attempt - to place a (sliding) holder with a guide roller for the filament bowden on the frame of the printer. This way of guiding can be combined with the hinged lid of the enclosure, when removing the printer, the bowden pulls out easily..

It has not yet been tested in the long term. But inserted bowden cylinder rotates flawlessly, the whole holder slides on the frame if necessary, so far everything OK.

***

Prusa enclosure je bezva, ale nelíbí se mi vedení filamentu v dlouhé trubičce přímo do extruderu kvůli výměně barev a konci špulky. Zkusil jsem toto - https://www.printables.com/cs/model/348293-filament-guide-in-prusa-enclosure-in-old-way-veden ale není to optimální - možná by pomohlo vést dílkem celý bowden ale už jsem líný to zkoušet - musel by se asi předělat díl u špulky. Proto druhý pokus - umístit na rám tiskárny (klouzající) držák s vodicím válečkem pro trubičku filamentu. Tento způsob vedení lze zkombinovat se zvedacím víkem enclosure, při vyndavání tiskárny se bowden snadno vytáhne..

Prozatím není dlouhodobě odzkoušeno. Ale váleček s bowdenem se otáčí jedna radost, celý držák klouže v případě potřeby po rámu, zatím vše OK.

Tagi