Self Holding Pegboard Standoff
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
There are a lot of different pegboard standoffs, but I wanted one that would hold itself onto the back of the board…
- Ocena
- 5 / 5
- Polubienia
- 25
- Pobrania
- 171
- Wydruki
- 1
- Wyświetlenia
- 623
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
There are a lot of different pegboard standoffs, but I wanted one that would hold itself onto the back of the board without any glue or fuss, so I made this.
The top part is chamfered a bit to allow you to insert and twist this into the back side of your pegboard. The fit is tight because it needs to be, but with a twist they will go in.
Then you can place the pegboard on the wall where it will go and mark the locations where you need holes or anchors, remove the pegboard and place your anchors, then put the board right back and screw it in. Easy.
This is made for standard US/Canada pegboard with 1/4" holes...so measure and/or test one out first before you commit to a full build plate of these.
I printed in PLA with 3 walls and 20% infill and they are more than strong enough.
Happy organizing!
Category: Tool Holders & Boxes