22+ GR86/BRZ iPhone Mini Cupholder Dock
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An iPhone mini 12/13 cupholder dock for the Toyota GR86/Subaru BRZ.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 48
- Wydruki
- 0
- Wyświetlenia
- 1057
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Public Domain
Can be used in either cup holders. Only requirement is the use of an original iPhone lighting cable as the fitment tolerance are low in order to create a snug fit and not allow cable to become loose.
To setup; Route the cable, lighting connector-end first, through the front square hole and down the side entry, then simply slide cable towards the center (It should be a snug/tight fit). It helps to flip over the dock and let gravity guide the cable.
Only tested on a 2023 GR86, but 22+ GR86/BRZ should be exact same cupholders.
Shown sample was printed using a Bambu Lab X1C. I used supports for only the bottom rim and not for the square entry overhang, you could setup support for entry but that adds 3x time due to many filament changes.
This is my first 3d model, routing internals aren't the prettiest but they work.