Osmo Pocket case for use when the Thumb Wheel and filters are installed.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
6-1-2020 Updated to version 3.0. Previous design was generated from the original mesh and had a few issues that made…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 335
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution
6-1-2020 Updated to version 3.0. Previous design was generated from the original mesh and had a few issues that made it not workable for updates. This version is a complete redraw as a solid model but retaining all the same features. Per a request there is also a second version that provides an additional 7mm of clearance in front of the camera sensor if you want to leave on an ND filter or the Freewell wide angle lens (just remember to pop it of temporarily when you start up the Osmo). Let me know if you have any problems. I'll be printing one myself shortly to replace my original TPU printed V2.1. Thanks for the suggestion.
8-14-19 Updated to version 2.1. The charging port was off by 2mm from the original published design; fixed. If you printed version 2 it'll work, but it is tight. When I reprint I may print the entire design in TPU and see how that acts for protecting my Osmo.
This is a remix of a design done by Fangli, but his remix button was disabled so I published this as a new post.
It is a remake of the Osmo Pocket case which moves the strap and increases cutout to allow safe storage of the Osmo Pocket with the thumb wheel installed; and then safety placed in your pocket or bag. The original design published printed short and my pocket Osmo would not slide in so I increased the length by 1mm and now it slips in smooth without rattling from being to loose. I also changed the attachment area for the flexible strap that is printed separate in TPU and then glued on. My design provides a slip in pocket which you can then wick some thin CA glue down into the pocket with the TPU strap to lock it in. The TPU strap is reposted here without change from the original designer for your convenience. The original design provides a clever front pocket for storage or your phone connector accessory or the cover plate when not in use. Enjoy and provide some feedback. Thank you to Fangli for the oringal version of the design.
Print Settings
Printer Brand:
MK3
Printer:
Prusa i3
Rafts:
No
Supports:
Yes
Resolution:
0.2mm
Infill:
25%
Filament: SainSmart TPU Fluorescent Green
Notes:
Strap requires being printed in TPU of your color desire, no support. Support can be used in the USB C hole on the end but should not be required with good bridging settings. Support is required for the little strap button, so support from the build platform only should be all that is needed. Depending on the build platform you may want to use a brim to keep it from peeling a bit off the print bed if using TPU, which I suggest and has protected my camera from mild impacts.
Category: Camera