1 / 6
OFS3D - 3D Printable Arcade Stick (V1 BoomBox) — zdjęcie 1
1 / 6

OFS3D - 3D Printable Arcade Stick (V1 BoomBox)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The Open Fight Stick 3D (OFS3D) is a 3D printable modular arcade stick designed to be customizable and easy to print.

Ocena
5 / 5
Polubienia
46
Pobrania
377
Wydruki
4
Wyświetlenia
3456
Oceny
3

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Video Games
Licencja
Creative Commons — Attribution — Noncommercial

The Open Fight Stick 3D (OFS3D) is a 3D printable modular arcade stick designed to be customizable and easy to print. Each component of the OFS3D fits together using a similar concept to a tower joint and do not require traditional metal screws or fasteners. Magnets and concrete can be additionally added to the build to add strength to the joints and weight to the overall design.

Printable Quantities

  • Side Panel x 2
  • Side Panel Weight x 2 (Optional)
  • Top VLX, VLX+Reverse, Noir or Stickless x 1 (220mm or 240mm)
  • Bottom Plate x 1 (220mm or 240mm)
  • Side Panel Attachment x 4
  • Side Panel Screw x 4
  • Flexible USB Tension (Optional) x 1

Required Parts

  • For Stickless Build
    • 30mm Button x1
    • 24mm Buttons x16
  • For VLX/Reverse/Noir Build
    • Joystick
    • 30mm Button x8 (+1 for reverse)
    • 24mm Button x5
  • Arcade Encoder Board with Brook holes
  • F13x5x3mm Rectangular Magnets x8
  • Super Glue for Magnets
  • Optional
    • Flexible filament for cable relief
    • Small Zip Tie for cable Relief
    • Concrete or Cement Mix for weights (fill to desired amount, I measured 2.2lbs per side for the standard sides)

Suggested Printing Settings

  • 0.6mm nozzle makes stronger prints but 0.4mm works fine
  • 15% Infill for Side Panel, Side Panel Weight, Top, Bottom, and Attachments
  • 30% Infill, 4 perimeters for Side Panel Screws
  • 0.2mm layer height or above
  • Print side panel attachments horizontally, otherwise the legs will be too weak

Assembly is fairly straight forward. Screw the side panel attachments and screws together a few times before attaching them to loosen the plastic threads. Wire the buttons and PCB together before attaching the top to bottom pieces. Use a zip tie to secure the cable on the back of the case. Ensure the magnets are glued in the correct way, I usually start with the bottom plate, let it dry, then glue in the attachment magnets when I'm sure they are correct.

The weights can be filled with anything, but concrete is incredibly cheap and gives a great deal of weight for less than a dollar.

The case is designed to have multiple side panels, so you can have a small panel or a large panel for different setups. My plastic prints tend to bend a little bit while cooling so the attachments give the top panel strength and rigidity. Everything should slide smoothly together and should not require sanding.

Tagi