James Cameron's Avatar Logo
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
9 variants of the logo from the 2022 film "Avatar: The Way of Water".
- Ocena
- 4 / 5
- Polubienia
- 40
- Pobrania
- 361
- Wydruki
- 1
- Wyświetlenia
- 1280
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- 2D Plates & Logos
- Licencja
- Creative Commons — Public Domain
Multiple variants available. I recommend scaling up as much as you can as the tail on the default logo is very thin. If you are unable to do this due to print bed limitations I have included modified versions that should be easier to print.
1: Logo with no attached parts. 6 piece print.
2: Logo with debossed backing plate. 1 piece print.
3: Logo with debossed backing plate, cut out holes, pegs, and simple stand. 4 piece print.
4: Avatar logo with backing plate. 1 piece print.
The following models are modified to be easier to print at smaller scale. They are not accurate to the original logo.
5: Logo with debossed backing plate. Larger tail and legs. 1 piece print.
6: Logo with debossed backing plate. Larger tail and no legs. 1 piece print.
7: Logo with no attached parts. Larger tail. 6 piece print.
8: Logo with debossed backing plate. Larger tail. 1 piece print.
9: Logo with debossed backing plate, cut out holes, pegs, and simple stand. Larger tail. 4 piece print.
If you are going to print the logo with the stand - Don't forget to check the tolerances of the slots and pins. You can split the model into separate objects in the slicer.
The print in the irl picture is variant 2. I cut off a few mm from the top and bottom to save filament and speed up print time.