Waterfall Fountain
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I could not find a good fountain on Thingiverse so I decided to design my own one. The water flows down the wall then…
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 88
- Wydruki
- 0
- Wyświetlenia
- 1234
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Share Alike
I could not find a good fountain on Thingiverse so I decided to design my own one. The water flows down the wall then moves into the back section where the pump is situated. The pump then circulates the water to the top again. If you print this please post a make as I have not yet got round to printing it and would love to see what you guys have made. P.S. Please tell me if it works :)
Print Settings
Printer Brand:
Monoprice
Printer:
Mini Delta
Rafts:
Yes
Supports:
Yes
Resolution:
0.1
Infill:
20%
Filament: Any PLA or ABS Any
Notes:
The settings above are just the standard settings which I use for printing, use whatever works best on you printer. Also, be prepared to remove a lot of supports.
1.After printing find a suitable size pump (links to some good ones at the end)
2.Slot the pump in to the Back section
3.Fill up some of the gaps with silicone sealant.
4.Pour in enough water so the pump is submerged to the required level
5.fill in the rest of the gaps with silicone sealant.
Plug in the pump and you're ready to roll!
Category: DIY