End Feed Shuttle with Pirn
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an end feed shuttle with pirn. I used brass wire to make the loops and hooks for the tensioner and super glued…
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 43
- Wydruki
- 0
- Wyświetlenia
- 511
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
This is an end feed shuttle with pirn.
I used brass wire to make the loops and hooks for the tensioner and super glued them in the holes.
Two of the hooks for the take-up and exit are formed in complete loops the rest can be simple hooks.
Supports are required as well as sanding to get a smooth finish.
The smaller the layer height, the better for the overhangs.
A double-ended bobbin winder is best used for winding the thread on the Pirn.
Use different hooks to route the thread in the tensioner to adjust the tension for your weaving.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
Yes
Resolution:
na
Infill:
na
Filament: generic pla wood filled PLA wood
Notes:
supports are required
the smaller the layer height the better for the overhangs
Post-Printing
Sand smooth to prevent snags while weaving
super glue the tension hook in the holes. i did not use all 9 holes
Category: DIY