1 / 7
Chunky M8 Knobs (DIN type, 13mm head or nut)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A set of snug-fitting, strong knobs made for M8 fasteners - nuts or bolts.
- Ocena
- 4,8 / 5
- Polubienia
- 52
- Pobrania
- 372
- Wydruki
- 5
- Wyświetlenia
- 1058
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (8)Wydruki i komentarze (Wydruki: 5) (Komentarze: 9)Remiksy (0)Kolekcje (99)Powiązane
Chunky knobs made for a snug fit with M8 hexagonal bolts or nuts. Modelled to work best with normal DIN standard fasteners (13mm across flats and head height 5-6mm to 6.4mm.)
Initially made for using with the partially-threaded bolts pictured; I decided to do some variations and this (fairly limited) set is the result.
Printing Notes
- Depending on how your nuts/bolts/printer/settings/material etc. the fit will vary - so try the test model first to find the fit you require, then alter the 'XY Size Compensation' by 0.1mm at a time to adjust if needed. I have only printed them in PETG so far but noticed a 0.6mm nozzle results in a tighter fit than with a 0.4mm. (different filament brands did not make a difference in this case.)
- Printing either way up is fine but use supports for the hex hole when that's facing the bed.
- 3 perimeters and 20% infill seems strong, but you can probably get away with less.