Einstar Handle MK1
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A handle for the Shining3D Einstar 3D Scanner that improves the ergonomy significantly.
- Ocena
- 4,667 / 5
- Polubienia
- 19
- Pobrania
- 450
- Wydruki
- 7
- Wyświetlenia
- 3840
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
This grip works great, but if you are new here, I recommend that you instead print my MK2 grip instead:
https://www.printables.com/model/388834-einstar-handle-mk2
This is my attempt at making an ergonomic grip for the Einstar, it is inspired by the grip of the Einscan Pro HD that I really quite like, and I am really happy with how it turned out!
I use the fuzzy skin setting to get a good grip texture
https://all3dp.com/2/cura-fuzzy-skin-simply-explained/
https://help.prusa3d.com/article/fuzzy-skin_246186
To save some time, I use the “Fuzzy Skin Outside Only” setting in Cura.
You can print this in 4 ways.
1.) You have a dual material printer and want a TPU grip
- Download the dual-material body and grip
- Merge them in your slicer and set the grip to print with TPU.
- I recommend that you turn on “fuzzy skin” for the grip part to get texture
2.) You have a single material printer, but still want a TPU grip
- Download the dual material body and the two separate_grip halves.
- Print the main body which will require supports to be turned on.
- Print the two grip halves in TPU.
- If you want to use “fuzzy skin” to get a grippy texture, be ready that you might need to sand the inside a bit to make it fit again.
- Use contact cement or epoxy to glue the grip halves to each other and the body.
3.) You have a single (or dual) material printer, and want a textured grip
- Download the dual-material body and grip
- Merge them in your slicer
- Select the grip part and enable “fuzzy skin”
4.) You have a single extrusion printer and don't care about grip texture
- Download the single material version and print it.
For all of the versions, you need to print two up/down buttons and one middle button. These prints laying flat on the build plate with the “rails” towards the build plate.
All the body part prints standing on their “back”.
I recommend printing the body in a rigid material of your choice, and for the grip, the softer the TPU is, the better.
To mount it, you will need one of these tripod screws:
https://www.amazon.se/dp/B08SKJRRQC
If you don't want to get them, you can a similar one or use any short ¼"-20 screw of your choice (around 10mm in length).
#Einstarhandledesign