Paper Towel Holder - Command Strip Optimized
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix to remove screw holes and widen base for more command strips.
- Ocena
- 5 / 5
- Polubienia
- 10
- Pobrania
- 114
- Wydruki
- 3
- Wyświetlenia
- 591
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Public Domain
This is a remix of the great paper towel roll holder by ÖE to better support using command strips since I'm renting and can't go drilling holes in the cabinets. The Papertowel-a-nohole v2 was my first version where I just removed the screw holes, but was pulled off the strips when with an aggressive yank for paper towels.
Then I created Papertowel-a-nohole-Extended where I cut off the base and replaced it with my own that would easily support two of the Large Picture Hanging strips each. So far it seems to be holding on much better!
Neither part needs supports and should import into the slicer with the correct orientation. To improve the thread quality, I had good luck increasing the number of walls to 4. The amount of Infill is not super important, but I printed the holder at 15% and the screw at 10%.
You will need to print two of your preferred holder and two of the screws (Papertowel-b). I have included the files for the screw, but I would like if you would go back to the original creator and drop them a like!