1 / 8
Dual horn cooling fan duct for TRONXY XY-3 SE — zdjęcie 1
1 / 8

Dual horn cooling fan duct for TRONXY XY-3 SE

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The dual horn cooling fan duct which is optimized by CFD for better cooling.

Ocena
5 / 5
Polubienia
5
Pobrania
68
Wydruki
1
Wyświetlenia
731
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a compact diagonal flow dual horn cooling duct for the TRONXY XY-3 (XY3) SE series 3D printers. Which used the original side cooling fan and designed fits in the original head cover. Which is optimized by CFD for better cooling than the original duct at the same air volume.

Optimized by CFD

Analyzed by CFD the air flow is designed to focus just under the printing nozzle. And the horns are not face-to-facing and bit offsetted to provide exhaust flow toward the left rear that suppresses turbulence around the model.

Front View: The cooling air just focused under the nozzle.Top View:  The main exhaust flow to the left rear by bit offsetted horns.

Printing and Material

ABS or any other high temperature material is recommended. Using brim and the draft shield is better. The STL contains a builtin support for the mounter bracket and no additional supports required. Remove a builtin support after the print.

Install

BOM: M3x12 1pc

Uninstall the side fan and original duct first. Then remove the screw on the bottom of the hotend cooler and replace it with a M3x12 screw to install the printed duct into the bottom of the head cover. Finally, re-install the side fan.

Visualized results

On the test which is visualizing air flow by using water surface the air focused under the printing nozzle and it shows a symmetrical dimple.

Fan power: 50%Fan power: 100%