Bambu Lab X1 Overengineered Y-Splitter with magnets
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of Bambu Lab X1 Overengineered Y-Splitter with magnets
- Ocena
- 0 / 5
- Polubienia
- 55
- Pobrania
- 326
- Wydruki
- 1
- Wyświetlenia
- 4742
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bambu Lab Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Remix of the best Y-splitter from Brandon Raineri .
I wanted the same, but with magnets.
What changed:
- added magnets (10 x 1.5 mm)
How it's printed:
- Filament: PC
- Quality : 0.1 mm
- Support: yes
Additional materials:
- Magnets 12 x 1.5 mm.
Original description:
Here is a remix to the original Y-Splitter for the Bambu Lab X1. This allows you to run material from the AMS or external spool without having to disconnect the PTFE tubing.
This uses push to connect fittings as you would see in a typical PTFE connector.
QTY: 3 of McMaster PN: 5472K101 for 4mm OD Hose
https://www.mcmaster.com/5472K101/
You only need the Release Ring and O-Ring from these assemblies. After you insert the PTFE tubing, pull back so the release ring has a gap between it and the print. While maintaining this gap, push the PTFE back in so it seats. The retaining ring should then firmly keep the PTFE bottomed out in the adapter housing.
Print with single inlet side on the build plate. Add a 10mm brim to stabilize the print.