1 / 2
Ender 6 Extruder hole filler
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modded filler for extruder hole with support for reverse bowden & filament sensor.
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 70
- Wydruki
- 0
- Wyświetlenia
- 565
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 0) (Komentarze: 1)Remiksy (1)Kolekcje (23)Powiązane
Ender 6 extruder hole filler for direct drive or repositioned extruder. Modified to include fit for reverse Bowden tube and filament sensor.
Hardware needed:
- 1 x M6 passthrough fitter.
- 1 x Socket bolt M3x12
- 4 x Socket bolt M3x10
- 4 x Conical head M3x20 (to mount the original filament sensor).
Instructions:
- Mount the filler plate with the original screws.
- Screw the fitting on the fitting mount.
- Mount the fitting mount on the filler plate with the conical hole on the bottom with 2 M3x10 screws.
- Use 2 M3x10 screws on the bottom of the filler plate just 1mm protruding the plate and the M3x12 in the middle just at the level of the plate. Screw the mount guide with the M3x10.
- Mount the filament detector on the detector plate with the 4 M3x20 srews.
- Insert the detector plate on the mount guide.
- Insert the bowden tube on the fitting.
- Align the holes with a M2 hex key.