Bambu Carbon X1 Purge Bucket (XL)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
XL - Purge Bucket (Poop Bin)
- Ocena
- 5 / 5
- Polubienia
- 11
- Pobrania
- 128
- Wydruki
- 1
- Wyświetlenia
- 816
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
XL - Purge Bucket to catch the purge filament 'droppings' that come out of the back of the Carbon X1.
I know there are several of these already out there, but I wanted to make one that was XL in size as I have room on the table behind my Carbon X1. Unfortunately, you will need a larger printer to print this bin as it is 270x190x160 and won't fit on most typical ~200x200 printers. This was inspired by others that are out there, again I just needed a larger one.
2 versions available: 1.6mm and 2.00mm thick
PLA
0.20 layer height (or higher) will be fine
10% infill (what I used, only need at very bottom)
No supports needed
(I used 0.60mm nozzle w/0.40mm layer height)