Blast Gate / Dust Gate / Sperrschieber
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Blast Gate for HT pipes Currently available for: DN 50 DN 40 Available in different lengths: DN50: 25mm and 47mm DN40:…
- Ocena
- 4,5 / 5
- Polubienia
- 102
- Pobrania
- 545
- Wydruki
- 7
- Wyświetlenia
- 3547
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Blast Gate for HT pipes
Currently available for:
- DN 75
- DN 50
- DN 40
Available in different lengths:
- DN50: 25mm and 47mm
- DN40: 25mm and 40mm
Available in different versions:
- Do --> outer Diameter of 3D part is 50, i.e. fits into sleeve
- Di --> inner Diameter of 3D part is 50, i.e. pipe fits into 3D part.
Remark:
- any combination within a certain diameter are possible, so also Di_lower with Do_upper, in case one side goes into the pipe, and on the other end, the pipe goes into the part.
- slider and middle are identical for Di and Do versions.
All you need for assembly are:
- 6 M4x16 mm hex head bolts
- 6 M4 nuts
- 6 washers for M4 (optional)
Feel free to support me by donations via Paypal, see link in Bio. - THANKS!
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.25
Infill:
20
Filament: Anycubic PLA grey
Notes:
suggested to make a print of a section to check if the tolerances are matching to your print settings. Otherwise you might need to adapt the XY offsets, or scale the part slightly.
Consider at least 3 outer perimeters.
Category: DIY