Shorty Pool Cue/Jump Cue Grip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Shorty pool cue grip for making a jump cue, or those tight areas around your pool table when you need to use a short cue
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 44
- Wydruki
- 0
- Wyświetlenia
- 605
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Indoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I needed to cut a cue short due to a couple of restrictive spots where my pool table is in my basement. After cutting the cue short enough, getting a good grip on the cue is difficult due to the small diameter of the remaining cue.
I designed this to help alleviate the issue, allowing for a decent grip to still be had even with the shorty cue. This makes playing in those tight spots a lot easier going, allowing you to make half decent shots. It also happens that this grip also makes for a great jump cue grip.
Currently this is dimensioned to taper from 19.2mm to 17.4mm. The outside grip is 40mm in diameter (some will likely find this too chunky). The model will potentially need to be scaled as required to fit your cue depending on where you cut it. My cue was cut to 26.5" in length.
Designed to press fit onto the cue, simply slide the larger diameter end over the tip of the cue and press fit at the bottom.
MY PRINT SETTINGS:
| Printer | Print Time | Layer Height | Nozzle | Material | Filament | Infill |
| Bambu Lab P1P | 1h15m | 0.24mm | 0.4 | PLA | 42.34g | 25% |