Wall Mount with Hanger for OWC Thunderbolt 3 Dock
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I needed to mount my OWC Thunderbolt 3 Dock to the wall behind my computer, but didn't want the installation to be…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 315
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
I needed to mount my OWC Thunderbolt 3 Dock to the wall behind my computer, but didn't want the installation to be permanent or require any tools to take off the wall for maintenance or anything. The dock is also too large for my print bed, so I needed a mount that was smaller than the device itself.
So, this mount comes in two pieces, a wall mount that gets screwed to the wall, and sleeve hangers that slide over the dock and then hang on the wall mount. The sleeves have openings at the bottom so that ports aren't covered up.
The sleeve probably only fits the OWC Thunderbolt 3 Dock, but with some adjustments to the dimensions of the sleeve, the design could easily mount just about any similar device.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
Yes
Supports:
Yes
Resolution:
.3
Infill:
100
Filament:
Hatchbox PLA
Notes:
Glass Bed temp: 65c
Nozzle: 195c
Category: Office