Toy Car Bridge
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Arch bridge with ramps
- Ocena
- 0 / 5
- Polubienia
- 40
- Pobrania
- 156
- Wydruki
- 1
- Wyświetlenia
- 1286
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial
The bridge is sized for HotWheels-style cars. It is a full-width print on a Prusa i3 MK2/3[S][+]. When its done you'll end up with three components: the center span and the two approaches. See the gcode notes for the quantities needed for each printed part.
The yellow lane marker is achieved with a color change.
The only parts with support are the road deck for the approaches. It is slightly annoying to remove. You may get acceptable results without support, but I didn't try. If you do, please let me know in the comments!
The assembly instructions are the same for the center span and the sides. You just need super glue, a couple spring clamps, and a weight
- Lay one of the side pieces on its side on a flat surface (blue parts in the picture
- Glue the middle piece (orange in the picture) in place
- Place a weight over this and wait for it to dry
- Glue the other side piece (blue) in place
- Glue the road deck in place and secure with a spring clamp
- Again use a weight to hold the assembly down
Assembly isn't hard, but I also didn't optimize the design for super quick assembly. Please post any questions or suggestions!