1 / 5

Anschütz magazinecap

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A magazinecap to replace the boring stock one with a more personalized variant with better grip.

Aktualizacja u źródła: 23 sty 2023

Informacje o modelu

Anschütz magazinecap for short magazines.

Print settings:

.2mm Layer heigt
.4mm Line width (for .4 mm nozzle)
2 Walls
3 Top layers
2 Bottom layers (14 Initial bottom layers if that setting exists to make the “hook thing” that hold on to the magazine itself stronger)
Ironing can be enabled for a smoother top surface but not necessary
20% Infill (with those 14 bottom layers, otherwise I would recommend higer infill %)
No support
Coasting enabled

If you use Cura I recommend using the “Enable Bridge Settings” in the experimental tab.

The model has some parts to help with adhesion that will need to be cut off after.

(Don't worry about the scuffed top on the blue one, I was impatient and had printed it with a raft)