Bomb shaped Zipper Pull for 550 paracord
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I found a few of these bomb beads for paracord, but they just didn't print nicely or work well as zipper…
- Ocena
- 5 / 5
- Polubienia
- 59
- Pobrania
- 231
- Wydruki
- 8
- Wyświetlenia
- 922
- Oceny
- 8
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I found a few of these bomb beads for paracord, but they just didn't print nicely or work well as zipper pulls/toggles.
After a few goes at designing , I cam up with something that worked, looked good, and printed easy. I like that it hangs from zippers like the bomb is dropping.
Print Settings
Printer Brand:
SeeMeCNC
Printer:
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.2 mm
Infill:
15%
Filament: Amazon PETG Post-Printing =============
Assembly
It should come off the printer with no need for clean up.rnrnGet your 550 paracord, cut it to a length you want. I wanted mine short and cut lengths of about 20-25 cm.rnrnNext, you need to gut the cord. Pull out the small inner strands so that the cord gets thinner. rnrntie your double not at the bottom rnrnfish one of the strands through the bottom of the bomb (small hole) and use it to pull the paracord up through the bomb so that the knot slides all the way in, and out of sight. rnrnif the tails on our knot stick out, pull the knot tighter, cut off and fues the tails with a lighter or match.
Category: Accessories