Plastic Bag Caddy
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is something I have been working on for a while now and finally had the time to put some thought behind it. It is…
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 213
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is something I have been working on for a while now and finally had the time to put some thought behind it. It is a handle with modular hooks that can carry several plastic bags at the same time. I used to just grab as many in one hand as I could and I would have blood circulation problems and pain from the plastic digging in. With this doo-hickie, I can carry much more with much less pain!
I printed this on a da vinci 1.0 (repetier 0.92 and Cura) with the following specs:
0.2 layer heigh
0.8 walls, top and bottom layers
30% infill
50 mm/s
The Handle takes about 5.5 hrs to print (i didnt use supports and had a little clean up to do for the bridges) and the hooks take 30-45 min with the same profile specs ( no cleanup necessary for those )
Instructions
- Print the handle file flat(0.2 layers are probably best)
https://youtu.be/Qu7dgOT9xIc 2. Print 3 hooks flat (0.2 layers are probably best) https://youtu.be/AAWkr0SJE5U 3. Get some "binding posts" from a hardware store. The holes in this model are 6mm in diameter and fit the 1" 8/32 aluminum binding posts from ACE Hardware. ($0.95/each) 4. Assemble and enjoy!
Category: Kitchen & Dining