Memobottle Desk Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple holder to show off your memobottle
- Ocena
- 5 / 5
- Polubienia
- 2
- Pobrania
- 47
- Wydruki
- 1
- Wyświetlenia
- 496
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
This model holds all bottles in the horizontal position, and holds the A6 and A7 vertical too. The center of gravity is too far back for the A5 and slim bottle to be held vertical. The stand is angled 41 degrees and has a slight lip so the bottles cant slip downwards. The angle of the lip was modeled after the bottom of the A6, and only after printing I found out that all sides of the bottles are different. This does not affect the ability of the stand, but there are slight gaps when holding bottles in different orientations.
Version 2 was a complete redesign, but functionally v1 accomplished the same purpose. V1 is a quicker print and takes less material, but I didn't fit it to the bottle so it just sits in it. I figured out that both 15mm V1 prints were enough together to hold all bottles just barely, so I increased the V2 to 45mm.
I printed this on its side and added a single layer cylinder to the tips in order to keep it from warping. This was printed in Overture PETG on a Prusa Mk3s+ with a .4mm diamondback nozzle.