Glue Bottle Holder for 3" Slatwall
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Glue bottle holder that fits Titebond and Weldbond bottles for standard 3" Slatwall such as storeWall.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 248
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A glue bottle holder that fits Titebond and Weldbond bottles using the same base clip as my other Slatwall models. For standard 3" Slatwall but has only been tested with storeWall as that is what I personally have installed.
Features an opening that can help pry open standard glue bottle heads, as well as a ridged section for scraping dried glue off.
I spent a lot of time trying to tweak the dimensions so that the parts would latch onto the Slatwall but not marr PVC Slatwall, but you should file the little latching nub down as needed to avoid any damage. Don't force it onto your wall if you feel too much resistance.
These must be printed with supports and on their sides for strength. If you have good build surface adhesion you can get away without a brim, but the little thin part that latches up into the slatwall has a tendency to warp and pull away from the build surface.