Multi-Tool Blade Holder for 3" Slatwall
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Multi-Tool blade Holder for standard 3" Slatwall such as storeWall.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 91
- Wydruki
- 0
- Wyświetlenia
- 556
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A Multi-Tool blade Holder that uses the same base clip as my other Slatwall models. For standard 3" Slatwall but has only been tested with storeWall as that is what I personally have installed. The blade holder part is more or less the same as my version for Wall Control as well.
I spent a lot of time trying to tweak the dimensions so that the parts would latch onto the Slatwall but not marr PVC Slatwall, but you should file the little latching nub down as needed to avoid any damage. Don't force it onto your wall if you feel too much resistance.
These must be printed with supports and on their sides for strength. If you have good build surface adhesion you can get away without a brim, but the little thin part that latches up into the slatwall has a tendency to warp and pull away from the build surface.